While at Stampin' Up!s convention, I presented a project at my uplines demonstrator gathering. I liked this card so much, we made it at our Stamp Club meeting too.
Stamp Club members receive instructions for most of the projects we do. All products used in this card can be purchased from Stampin' Up! Order online at www.stampwithwanda.stampinup.net
Card Directions
For this card, you will need the following:
Stamps:
- Gifts of Christmas
- Snow Much Fufn
Ink:
Paper:
Cherry Cobbler Card Stock
- One 4.25 x 5.5 for backing
- One 3.75 x 4 for snowman backing
- One 1.25 x 4 for belly band layer
Always Artichoke Card Stock
- One 4.5.25 for base card layer
- One 3.75 x 4 for Easel
- One 1.5 x 11 for Belly Band
- One 1 x 2.5 for the slider attachment
Soft Suede Card Stock
- One 3.5 x 3.5 for layer under the snowman
Very Vanilla Card Stock
- One 3.5 x 3.5 for scalloped edge Snowman image
- One 3.75 x 3.75 for inside sentiment
- One 1 x 2.75 for "Christmas Wishes"
Punches:
- 1 3/8 Circle
- Scallop Edge
Big Shot:
- Scallop Square Duo Die
- Lattice Embossing Folder
Other Accessories:
- Gold Chunky Glitter
- Dimensionals
- Sticky Strip
- Blender Pen
Step 1: Attach Always Artichoke backing layer to Cherry Cobble backing.
Step 2: Stamp and attach the inside sentiment to backing layer.
Step 3: Cut Whisper White scallop square using the Scallop Square Duo Die -- the largest scallop square of the two. Stamp snowman and color using ink pads and Blender Pen.
Step 4: Attach Sticky Strip tape to edges of Soft Suede square. Attach glitter.
Step 5: On Cherry Cobbler (3.75 x 4 square), score at 3.75. Attach glittered square to 3.75 x 4 card stock above the scored line. Use dimensionals to attach the scallop snowman image to the glittered square. Apply Sticky Strip tape below the scored lineon the remainng .25. Crease on score line.
Step 6: Score the Always Artichoke Belly Band at 3 and 7 3/8. Cut a 1/2 circle using the 1 3/8 circle punch, on the center edge of the belly band. Decorate Belly Band. Fold and attach band to itself. Slip belly band onto the card backing. Attach the 3.75 x 4 card stock to the belly band underneath the front of the belly band.
Step 7: Score Always Artichoke 1 x 2.5 slider attachment card stock at .5 from each end. Fold card stock in accordian fashion (looks like a 'z'. Apply sticky strip to the top of the scored easel card stock just above the score line. Attach the sticky strip end of the 'z' to the back of the snowman layed image about .5" from the top edge, centered. Flatten out the 'z' shaped card stock. Apply Sticky Strip to the bottom .5" segment on the opposite side from where the other sticky strip was placed -- it will be attached to the backing.
Step 8: Insert the belly bank onto the backing. Position belly band and snowman layered image so that it is centered onto the card. Attach the straighted 'z' card stock to the layered backing.
Step 9: Push the belly band towards the top edge of the card. The snowman image should 'pop up' like an easel.
WOW! That's a lot of instructions! I hope they make sense. If not, let me know.
Enjoy!





